AGA GC 3 Wartungshandbuch PDF herunterladen (Seite 21)

D. TO CHANGE IGNITION ELECTRODE

1. Turn off electricity supply.

2. Remove Top Plate and Hotplate (See sections A and B).

3. Disconnect the electrode cable from the ignition generator.

4. Remove spring clip retaining electrode to burner body (See Fig. 13) and remove electrode

and cable.

5. Replace with new electrode ensuring spring clip is correctly located into burner body.

6. Re-assemble in reverse order and check operation of ignition to hotplate burners.

E. TO CHANGE HOTPLATE GAS TAP

1. Turn off gas supply and electricity supply.

2. Remove Top Plate and Hotplate (see sections A and B).

3. Remove controls mounting plate by removing the 6 screws (As shown in Fig. 14).

4. Disconnect supply pipes from rest of all 4 gas taps and pull wiring off tap switches.

5. Disconnect gas rail tube and remove 4 screws from gas rail support brackets. (See Fig. 15).

6. Remove gas rail/taps assembly and remove appropriate tap by removing 2 screws. (See

Fig. 16).

7. Re-assemble in reverse order ensuring that the sealing ring is correctly located between

the new tap and the gas rail. (Rewire as circuit diagram).

8. Check for gas soundness before fitting hotplate and top-plate.

9. When re-assembled, check for correct operation of tap/tap ignition switches.

F. TO CHANGE OVEN THERMOSTAT/GRILL CONTROL

1. Turn off electricity supply.

2. Remove hotplate and top plate (see sections A and B).

3. Remove two screws retaining the thermostat/grill control to the controls panel.

4. Pull all of the wiring off the thermostat or grill control. The grill control can now be

removed.

5. From inside the oven, unclip thermostat phial.

(Top oven phial located at rear of oven; lower oven phial located at top right hand side).

6. Feed phial through hole in oven, then pull capillary up from side of cooker to remove

thermostat.

7. Re-assemble in reverse order, ensuring thermostat phial and capillary are not damaged

and phial is correctly located into retaining clips. (Rewire as circuit diagram).

8. Check operation of oven thermostat phial or grill control.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Keine Kommentare

AGA GC 3 Wartungshandbuch Seite 21