AGA GC 3 Wartungshandbuch PDF herunterladen (Seite 17)

6. Remove the terminal block cover screws located on the back of the range.

7. Make the four-wire connection following the “Power supply cord method”.

Power supply cord method

This range is manufactured to use a four-wire power supply cord rated at 250-volts, 30-amperes

(See “Four wire electrical connection”)

1. Assemble a U.L.-listed strain relief in the opening.

2. Insert the power supply cord through the strain relief, allowing enough slack to easily

attach the wiring to the terminal block.

3. Use only ring-type terminals to connect the power supply. To secure the power supply cord

use 6mm (1/4”) brass terminal nuts attached to the inside of the terminal block cover.

Be sure nuts are installed tight.

4. Complete electrical connection.

WHITE

(NEUTRAL)

GREEN

(GROUND)

Fig. 9

DESN 511752

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Keine Kommentare

AGA GC 3 Wartungshandbuch Seite 17