AGA GC 3 Wartungshandbuch PDF herunterladen (Seite 20)

AGA

COMPANION/MODULE (with Gas Hob Unit)

SER

VICING NOTES

DISCONNECT FROM ELECTRICITY SUPPLY BEFORE SERVICING.

WHEN REWIRING ANY ELECTRICITY COMPONENTS REFER TO CIRCUIT DIAGRAM AND

ELECTRICAL SCHEMATIC DIAGRAM ATTACHED BEFORE ELECTRICAL RECONNECTION.

CHECK THAT THE APPLIANCE IS ELECTRICALLY SAFE.

NOTE: TURN OFF GAS SUPPLY TO COOKER BEFORE SERVICING ANY GAS CARRYING

COMPONENTS. ALWAYS CHECK APPLIANCE FOR GAS SOUNDNESS AFTER

COMPLETION.

NOTE: USE SOAPY WATER SOLUTION TO ENSURE THERE ARE NO GAS LEAKS

A. REMOVAL OF TOP PLATE

1. Disconnect from electricity supply and remove pan supports and all control knobs.

2. (a) MODULE ONLY

Remove the handrail from the module top plate (See Page 25). Slacken grub screws

and remove socket screws from the jointing bracket to remove rail.

(b) MODULE ONLY

Remove shroud (if fitted) from rear of top plate.

MODULE AND COMPANION

3. Remove left hand and centre shrouds from the control panel to gain access to the fixing

screws.

Remove two screws from control panel (one from left hand hole and one from centre hole)

(See Fig. 3).

4. Carefully pull top plate forwards slightly and lift up at the front. Support top plate and

disconnect the wiring to the neons.

Remove top plate.

5. Lay the top plate on its top face, suitably protected.

6. Re-assemble in reverse order.

B. REMOVAL OF HOTPLATE

1. Repeat operations 1 to 5 of section ‘A’.

2. Remove burner heads and burner caps.

3. Remove all of the screws retaining hotplate burner trims (4 from the Wok burner, 2 each

from the other three burners). (See Fig. 4).

4. Carefully remove burner trims and gaskets, taking care not to damage gaskets or burner

electrodes.

5. Disconnect earth wire from left hand control panel mounting bracket.

6. Remove Hotplate.

7. Re-assemble in reverse order, ensuring burner heads and burner caps are correctly

located and electrodes are not damaged. (See Figs. 8A, 8B and 8C).

C. TO CHANGE IGNITION GENERATOR

1. Turn off electricity supply.

2. Remove Top plate and Hotplate (See sections A and B).

3. Remove two screws retaining the generator fixing bracket to the burner mounting panel,

and remove generator (See Fig. 11).

4. Carefully remove all wiring from ignition generator (Fig. 11).

5. Re-assemble in reverse order and check operation of ignition to hotplate burners.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

AGA GC 3 Wartungshandbuch Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Herde AGA GC 3