AGA GC 3 Wartungshandbuch PDF herunterladen (Seite 11)

9. Levelling of the Simmering Plate on the main cooker can be carried out with its top plate

in position and verified across the Module (See Fig. 7).

10. Complete the main cooker build and loosely screw down the top plate.

11. Apply tape (provided) to the underside of the lap strip on the Module top plate.

12. Replace module hotplate. Reassemble in reverse order (See section 4). Ensure burner

heads and burner caps are correctly located (See Fig. 8A, 8B and 8C) and electrodes are

not damaged.

13. Replace Module top plate as follows:-

a) Support top plate at front and reconnect the wiring to the two neons.

b) Carefully lower the top plate into position taking care not to damage wires or neons.

c) Ensure holes for control spindles are aligned correctly, and replace 2 screws into

control panel.

d) Loosely screw the top plate down with 4 retaining screws.

14. Verify that the two top plates are level.

15. Secure handrails as shown on Instruction Sheet Page 26.

16. Finally tighten both top plates.

Commission the main Aga cooker, as stated in the relevant Installation Instructions and carry out

functional tests on each of the features on the Module (See Users Instructions).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Keine Kommentare

AGA GC 3 Wartungshandbuch Seite 11