09/13 EINS 516417PLEASE READ THESE INSTRUCTIONS BEFORE COMMENCING SITE SURVEYOR INSTALLING THIS APPLIANCE.REMEMBER: when replacing a part on this appl
HOTCUPBOARD INSTALLATIONFig. 5 DESN 516448Fig. 6 DESN 51644910NOTE: The AGA TC5 hotcupboard should arrive with the top plate in a jacked up position.
2. Position the plinth alongside the AGA Total Control leaving no gap between the two plinths (See Fig. 7).Check with a spirit level that the plinth l
4. Run a straight edge along the front of the AGA Total Control plinth, to ensure the front face of both plinths sit squarely against the straight edg
Fig. 11 DESN 5165527. The hotcupboard top plate is set 5mm higher than the AGA Total Control top plate. This is toprevent damage to the enamel during
8. Using the stay rod nut adjusting tool, carefully lower the top plate adjusting nuts until the topplate sits at the required height, making sure tha
15HANDRAIL CONNECTION - AGA TC3Fig. 15 DESN 516560Handrail brackets, endcaps and handrail require assembly.Locate endcaps onto handrail, place bracket
WIRING DIAGRAM - AGA TC3 (ROOM VENT OPTION)16Fig. 16
17Fig. 17WIRING DIAGRAM - AGA TC5 (HOTCUPBOARD OPTION)COLOUR KEYSBR - BROWNBL - BLUEGR - GREENOR - ORANGEBK - BLACKCAUTION: LABEL ALL WIRES PRIOR TODI
Tick Boxl Check hotplate lids settings.l Check oven door seals, adjust door alignment if necessary.Baking and Simmering Oven rope seals MUST have a ga
SECTION PAGEHEALTH AND SAFETY 3INSTALLATION REQUIREMENTS 3DELIVERY REQUIREMENTS 3APPLIANCE DIMENSIONS - AGA TC3 (ROOM VENT 4OPTION)APPLIANCE DIMENSION
20For further advice or information contactyour local AGA SpecialistWith AGA Rangemaster’s policy of continuousproduct improvement, the Company reserv
HEALTH AND SAFETYConsumer ProtectionAs responsible manufacturers we take care to make sure that our products are designed andconstructed to meet the r
4APPLIANCE DIMENSIONS - AGA TC3 (ROOM VENT OPTION)Fig. 1 DESN 516297Cooker DimensionsWhen surveying for a cooker installation the actual clearance req
APPLIANCE DIMENSIONS - AGA TC5 (ROOM VENT OPTION)5Fig. 2 DESN 516561Cooker DimensionsWhen surveying for a cooker installation the actual clearance req
CLEARANCESThe complete cooker is floor-mounted and the space in which the appliance is to be fitted musthave the following minimum dimensions:-A minim
POWER SUPPLY - AGA TC3/TC5 (ROOM VENT OPTION)WARNING: THIS APPLIANCE MUST BE EARTHED.THIS APPLIANCE IS DESIGNED FOR THE VOLTAGE STATED ON THE RATING P
MAINS CABLE ROUTING - AGA TC3 (ROOM VENT OPTION)Fig. 3 DESN 516420MAINS CABLE FED FROMCONTROL TRAY LEFT ORRIGHT EXIT THROUGHDUCTING DEPENDENT UPONPOSI
MAINS CABLE ROUTING - AGA TC5 (ROOM VENT OPTION)Fig. 4 DESN 516562MAINS CABLE FED FROM CONTROLTRAY LEFT OR RIGHT EXITTHROUGH DUCTING DEPENDENTUPON POS
Kommentare zu diesen Handbüchern